3 How do I connect the door strike to a TX3 series telephone entry panel?

  • Door strike power supply gets connected to the “Door Supply” terminal and the AC/DC door strike gets connected to “AC Door” or “DC Door”. Ensure that you use a separate power supply for powering the door strike.
  • If you are controlling the front main entrance with a non Mircom access control system, only tie the main door dry contact output (2 left screws of the AC door and Door supply terminals) from TX3-Voice Access to your 3rd party access control panel input (which can be assigned as a request to exit input). The door strike power will be supplied from the access control end in this case.
  • If you are using a Mircom’s access control system, then no wires are needed to activate the door strike. You can use correlations for controlling outputs on multiple panels that are connected with each other. For more information please read the instruction Manual.

Was this answer helpful to you?


Yes (2)    No (3)

Thank you! We will use your feedback to improve our frequently asked questions.
Thank you! We will use your feedback to improve our frequently asked questions.

Please contact Technical Support directly if you need further assistance.




GO BACK