I RS485 connected to the TX3-TOUCH via another Access Control panel and “sent” the full configuration to the TXTOUCH. The TX3-TOUCH system did not update its tenant’s list?

Since the TX3-TOUCH unit is network connected via RS485, you must tell it to update its tables from the telephone card. From this please go directly to the unit, open the TX3-TOUCH to its configurator and check the “Auto get Job”;

Restart unit and re-send the configuration file


Was this answer helpful to you?


Yes (0)    No (0)

Thank you! We will use your feedback to improve our frequently asked questions.
Thank you! We will use your feedback to improve our frequently asked questions.

Please contact Technical Support directly if you need further assistance.




GO BACK